Stainless Steel Nozzle Kit --- K-165

Stainless Steel Nozzle Kit --- K-165

  • $617.00


Specifications

Set of 7 sampling nozzles. May be of the button-hook or elbow design. Fulfills requirements on shape of inlet hole and angle of tapered edge. Comes in a padded box.

Components:

1x K-178 Empty Stainless Steel Nozzle Box
1x PN-377 Nozzle, Stainless Steel 316, Size 4
1x PN-485 Nozzle, Stainless Steel 316, Size6
1x PN-486 Nozzle, Stainless Steel 316, Size8
1x PN-487 Nozzle, Stainless Steel 316, Size10
1x PN-488 Nozzle, Stainless Steel 316, Size12
1x PN-489 Nozzle, Stainless Steel 316, Size14
1x PN-490 Nozzle, Stainless Steel 316, Size16
7x PN-906 O-ring, Viton, 014

Material/Measurements/Description:

316 Stainless steel

This set contains 7 nozzles of the following (nominal) sizes:
Size
Inches (Fraction)
Inches (Decimals)
Millimeters

Purpose and how to use? Relationship to other components?

The sampled flue gas enters the sampling train via the nozzle. Ideally, the velocity of the sampled gas should be the same as the velocity of the flue gas inside the stack (Isokinetic sampling ratio = 100%). A good diagram of this would be Figure D.1, Annex D, ISO 9096:2003(E).
The sharp tapered edge is to minimize the likelihood of solid particles getting sampled "accidentally".

Relevant texts/methods/requirements:

Section 6.1.1.1 (Probe Nozzle), USEPA Method 5
Section 6.2.2 (Set of entry nozzles) and Annex A, ISO 9096: 2003(E)

Additional ordering/shipping procedures:

None. Please refer to the FAQs page for shipping and other charges.

--

Information presented here is subjected to Aer Sampling Group's terms and conditions.
Doc ID: AERHQWW-k-165-en
Last revised (Excluding prices): 1; 23.09.18
Previous (Obsolete) Catalog ID: PN-378, UN-SK